Publicité
Les langues disponibles
Les langues disponibles
Instructions for use for the user
9.7. Cancelling the preset time function
● Press and hold down the preset time button
preset time function.
► The preset time countdown is cancelled.
► Then the current temperature in the sauna room is displayed in the
temperature display
is displayed.
The most recently selected preset time is saved, which means the last
value can be recalled at the touch of a button. To reset the preset time
to 00:00, press the preset time button for one second.
9.8. Activating standby for remote operation
EN 60335-2-53 specifies that sauna control units with a remote start function
must be set manually to "Standby for remote operation" mode. This activation
must take place again after each remote start and stop procedure. To do so,
perform the following steps:
1. Press the temperature selector
► The remote start indicator 8 starts flashing.
► The sauna control unit is then ready to be started and stopped using
a remote start signal.
► After a remote start and stop, the remote start indicator goes out and the
mode has to be activated again.
9.9. Switching off the sauna control unit
● Press the ON/OFF switch
► The temperature display
► The sauna control unit is switched off.
. In single-sensor mode, the preset temperature
3
for one second.
3
, to switch off the sauna control unit.
6
goes out.
4
for a second to cancel the
6
p. 26/30
Publicité
