Publicité
Les langues disponibles
Les langues disponibles
TOOLS AND PARTS
Gather the required tools before starting installation. Read and follow
the instructions provided.
TOOLS NEEDED
• Tape Measure
• Straightedge
• Pencil
• Philips Head Screwdriver
• Level
• Wire Cutters
• Wire Stripper
PARTS PROVIDED
PARTS
1" Screws
Screw Inserts
TECHNICAL DATA
ELECTRICAL RATINGS AND MAXIMUM CONNECTED LOAD
@ 240 Volts 60 Hz
@ 208 Volts 60 Hz
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances.
• Given cabinet opening dimensions must be used. Given dimen-
sions provide minimum clearance for oven.
• Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
• The oven support surface must be a minimum ¾" (2 cm) thick
plywood platform. The platform must support 100 lbs (45 kg) and
be solid, level and flush with the bottom of the cabinet cutout.
• Grounded electrical supply is required. See Electrical Require-
ments section.
• Electrical supply junction box should be located a maximum 3"
(7.6 cm) below the support surface when the oven is installed in
a wall cabinet. The support surface should have a minimum 1"
(2.5 cm) diameter hole drilled in the right rear or left rear corner
to pass the appliance cable through to the junction box.
NOTE: For undercounter installation, it is recommended that
the junction box be located in the adjacent right or left cabinet.
If you are installing the junction box on rear wall behind oven,
it is recommended that the junction box be recessed and located
in the upper center of the cabinet.
IMPORTANT: To avoid damage to your cabinets, check with
your builder or cabinet supplier to ensure the materials used will
not discolor, delaminate or sustain other damage. This oven has
been designed in accordance with the requirements of UL and CSA
International and complies with the maximum allowable wood
cabinet temperatures of 194°F (90°C).
E
INSTALLATION REQUIREMENTS
• Hand or Sabre Saw
• 1" Hole Saw
• Drill and Drill Bit
• Safety Gloves
• Goggles
• Volt Meter (0-250VAC)
QTY
2
2
13.3 A
3100 W
11.7 A
2350 W
PRODUCT DIMENSIONS
LETTER
23
3
/
" (58.9 cm) Height (overall)
A
16
21
11
/
" (55.0 cm) Width (recessed)
B
16
22
3
/
" (56.7 cm) Height (recessed)
8
C
22
7
/
" (57.0 cm) Depth (recessed)
16
D
23
7
/
" (59.5 cm) Width (overall)
E
16
1
24
/
" (61.6 cm) Depth (overall)
F
4
A
E
2
DIMENSION
B
F
C
D
Publicité
