Publicité
Les langues disponibles
Les langues disponibles
SPRAYER COMPONENTS & USE INFORMATION
CHARGING BATTERY
This sprayer comes with an enclosed 6V battery.
To get started use the charger provided to charge
the battery. The charger is located in the inner flap
of box.
Red Light - Indicates the battery is charging.
Green Light - Indicates the charge is complete.
FILLING THE SPRAYER
• Remove the Fill Cap.
• Make sure the filter basket is in place to keep debris from entering
the tank.
• Determine the amount of mixture needed for your application. Add the
proper amount of water to the tank. Add the proper amount of chemical
to the tank (check the chemical label for proper ratio of chemical). The
tank will hold the 16 ounces (.5L) total capacity.
• It is not necessary to completely fill the sprayer tank with each use. You
can fill the tank with only the amount needed for each application.
• Always follow the chemical manufacturer's instructions included on their
product label.
• Replace Fill Cap and hand tighten.
SPRAYING
Press the on button and release.
CLEANING
• Always empty the sprayer and clean the tank thoroughly after each use.
• Add clean water to the tank and swish around for a few seconds, then
pour out.
• Add a small amount of water to the tank and spray to remove residual
materials fromthe pump and nozzle. Spray until all liquid is out of the tank.
• If necessary, repeat steps 2 and 3 to insure the sprayer is clean.
Chapin Operator's Manual - English
2
Publicité
