V-TAC VT-5122 Instructions D'installation page 9

All manuals and user guides at all-guides.com
ENGLISH
A. DEVICE ADDING BY SCANNING THE CODE
• Tap on "device adding by scanning the code"(Ref Figure 6)
• Tap on the Checkbox.
• Tap on Connect to the Network
• Now If your mobile phone is already connected to network wifi, it will show your
network wifi name. If not, press "Switch the network" to open your phone's
WLAN and connect to your available network. Then go back to the app. Input wifi
password (note: this password must be your network wifi password), and then
click "Next". A QR code will show on phone screen.
• Place the QR code towards the camera lens at a distance of around 10~20cm.
After the camera reads the QR, it will sound with two beeps and voice "Network is
connecting, please wait". Now on App, press "I heard the beep voice". Then wait
till the camera confirms with "Wifi connection success" and finally "Camera is
online". On app it will also show "Addition is successful". Press "Start to experi-
ence".
FIGURE 7
FIGURE 8 FIGURE 9
8