Zephyr Essentials Napoli ZNA-E42CS Guide D'utilisation, D'entretien Et D'installation page 15

Mesh Filter Clean Indicator (always enabled)
- After 30 hours of fan usage the
the mesh filters. Graphic and words will remain illuminated until reset.
- To reset: With hood off, hold the
" will turn off and the 30 hour timer will reset.
filter
Charcoal Filter Replace Indicator (disabled by default, must be enabled if recirculating hood)
- To enable Charcoal Filter Replacement Function:
- With hood off, hold
three seconds indicating the Charcoal Filter Replacement Function is enabled.
- To disable Charcoal Filter Replacement Function:
- With hood off, hold
illuminated then turn off indicating the Charcoal Filter Replacement Function is disabled.
- After 120 hours of fan usage the
replace the charcoal filter. Graphic and words will remain illuminated until reset.
- To reset: With hood off, hold the
charcoal filter " will turn off and the 120 hour timer will reset.
Clean Air Indicator
- Clean Air is a feature that turns the fan on every 4 hours for 10 minutes to remove stagnant air in the kitchen.
- To enable Clean Air Function:
- With hood off, hold the
words "
clean air
will turn off and the 4 hour timer will begin.
- Graphic will remain on when Clean Air Function is enabled, even if fan is not on.
- To disable Clean Air Function:
- With hood off, hold the
turns off.
- When the Clean Air Function is enabled the fan will turn on speed 1 for 10 minutes every 4 hours of non fan usage. After 10
minutes the fan will turn off and the 4 hour timer will reset.
- If the user changes the fan speed while the Clean Air Function is in use, the words "
will remain illuminated. If the user presses the
Graphic and words " clean mesh filter
Button for three seconds, after three seconds the
Button and Button simultaneously for three seconds. The
Button and Button simultaneously for three seconds. The
Graphic and words "
replace charcoal filter
Button for three seconds, after three seconds the
Button and Button simultaneously for three seconds. The
" will illuminate and the fan will turn on speed 1 for 10 minutes. After 10 minutes the fan
Button and Button simultaneously for three seconds until
Button at any time the 4 hour clean air timer will reset.
13
" will illuminate indicating it is time to clean
Graphic and words "
Graphic will illuminate for
Graphic will be
" will illuminate indicating it is time to
Graphic and words "
clean air " will turn off but the
clean mesh
replace
Graphic and
Graphic
Graphic