Publicité
Les langues disponibles
Les langues disponibles
• Power management :
The hole cooking hob is equipped by a maximum of power. When the booster function is activated,
and not to exceed the maximum power, the electronic system orders to reduce automatically the
power level of an other heating zone. The display is blinking on [ r ] during a few seconds and then
shows the maximum of power allowed.
Heating zone selected
[ P ] is displayed
Timer
The timer can be used on all heating zones (from 1 to 99 minutes), but only on one heating zone at a
time.
• Setting and modification of the cooking time :
Action
To select « Timer »
Zone selection
Decrease the time
Increase the time
After 10 seconds the control light stops with blinking.
The time is confirmed and the cooking starts until the time reaches [ 00 ].
• Change settings of the cooking time :
Action
To select « Timer »
To stop the « Timer »
• Automatic stop at the end of the cooking time :
As soon as the selected cooking time is finished the timer displays blinking [ 00 ] and a sound rings.
To stop the sound and the blinking it is enough to press any key.
Control panel locking
To avoid modifying a setting of cooking zones , in particular with within the framework of cleaning the
control panel can be locked (with exception to the On/Off key [
• Locking :
Action
Start
Hob locking
• Unlocking :
Action
Unlocking the hob
Power Management
The hob is equipped with a power limitation. If you reach the maximum power it will be impossible to
increase the power on the different cooking zones and a beep signal will sound. This limitation is set
at 7200 W by the factory but it is possible to change it to 2800 W, 3500 W or 6000 W.
The other heating zone:
[ 9 ] goes to [ 7 ] depending the type of zone
Control panel
Press [ - ] or [ + ] of the timer
Press key [ - ] or [ + ] of the zone
Press key [ - ] of the timer
Press key [ + ] of the timer
Control panel
Press [ - ] or [ + ] of the timer
Press key [ - ] until [ 00 ] or press
Simultaneously [ - ] and [ + ]
Control panel
Press key [
]
Press [
]
Control panel
Press [
]
24
(example: power level 9)
Display
Timer [ 00 ] min
[ t ] on each zones
[ 00 ] blink on the timer, the
timer light of the zone is on
[ 00 ] wents to 99,98...
time increase
Display
The remaining time
[ 00 ] then stops
] and the lock key [
Display
3 x [ 0 ] or [ H ]
Lock light on
Display
Lock light off
]).
Publicité
