MOVING THE LOG SPLITTER TO THE WORK SITE
The log splitter is equipped with 2 wheels for minor
transportation. To move the log splitter to the work site:
grip the handle (1) to tilt the log splitter slightly after
making sure the oil tank cover is tightened.
If using a crane, lay hoist sling around the housing. Never
try to lift the log splitter at the handle (1).
5. OPERATION
▪
Plan your work site. Work safely and save effort by
planning your work in advance. Have your logs
positioned where they can be easily reached. Have a
site located to stack the split wood or load it onto a
nearby carrier.
▪
Prepare the logs for splitting. This log splitter
accommodates logs up to 1055 mm in length. When
cutting up limbs and large sections, do not cut sections
any longer than 100 cm. With 3 support table positions
for splitting for 575 mm, 770 mm and 1055 mm in
length. Insert the support table in position nearest the
log length and secure the support table with the locking
hook.
▪
A thin coat of grease to the surfaces of the ram before
operation will lengthen the durability of the ram.
▪ Route the power cord. Route the cord from the power source to the splitter in a
way that safeguards against tripping on the cord or the cord becoming
damaged during the work session. Protect the power cord from impacts, pulling
or corrosive materials.
All manuals and user guides at all-guides.com
23