Conceptronic CBTGPS32 Guide D'installation Rapide page 14

ENGLISH
4.2 Charging the battery
Before you use the CBTGPS32 for the first time, please charge the battery until it is
fully charged.
Connect the retractable USB cable to the Power Adapter, the Car cigarette lighter
adapter or a free USB port on your computer and connect the other end to the
power jack of the CBTGPS32 (mini USB type).
The battery will start charging.
When the battery is fully charged, the Battery Status LED will turn off.
4.3 Turn on the GPS Adapter
When the battery of the GPS Receiver is fully charged the device is ready to use.
Turn on the GPS Receiver with the power switch at the left side of the device.
The Bluetooth
Note: When the CBTGPS32 is used for the first time, it will take up to 3 minutes
to get the satellite constellation and fix your position; this is called "Cold
Start". If you replace the battery, the CBTGPS32 will do a "Cold Start"
again. When the battery is completely empty, the CBTGPS32 will also
perform a "Cold Start" after charging.
4.4 Pairing the GPS receiver with your Smartphone or PDA
You can pair your Smartphone or PDA with the GPS Receiver when the GPS Receiver
is turned on and not currently connected to another Smartphone or PDA.
Note: For pairing instructions we refer to the manual of your Smartphone or
PDA.
All manuals and user guides at all-guides.com
®
Status LED will turn on.
14