KRATOS SAFETY FA 20 400 07 Notice D'utilisation Et D'entretien page 7

This notice must be translated (possibly by the retailer) into the language of the country of use.
For your safety, comply strictly with the instructions for use, verification, maintenance and storage.
KRATOS SAFETY cannot be held liable for any direct or indirect accident occurring as a result of use other than provided for in this notice; do not
use this equipment beyond its capabilities!
USE AND PRECAUTIONS:
A retractable fall arrester is a piece of personal protection equipment; it should be allocated to a single user (it can only be used by one person at a
time). When the user moves (up or down), the cable winds onto and unwinds from a pulley. The cable is kept taut by means of a return spring. In the
event of a fall, a system locks the cable and prevents it unwinding, thus stopping the fall instantly.
User safety relies on the effectiveness of the equipment and full understanding of the safety instructions contained in this leaflet.
Product markings should be checked periodically for legibility.
The upper swivel is linked to an anchor point by a connector (EN362) and the other end (cable or strap) is attached onto a safety point on a harness.
Sharp edges, small diameter structures and corrosion should be avoided as they may affect the performance of the cable or strap; or they should be
adequately protected.
The anchorage point for the device should be situated above the user (minimum strength 10 kN). Ensure that the general arrangement limits
swinging in the event of a fall, and that the work is done in such a way as to limit the risk and the height of a fall.
For safety reasons and before each use, make sure that in the event of a fall there is no obstacle obstructing the normal deployment of the cable or
strap.
The minimum free space should be: 3 m under the user's feet.
HORIZONTAL USE:
KRATOS SAFETY retractable fall arresters (FA 20 400 06, FA 20 500 06, FA 20 400 10, FA 20 400 15, FA 20 500 12, FA 20 400 20, FA
20 400 25, FA 20 400 30, FA 20 600 06, FA 20 600 10, FA 20 600 15) have passed the tests for horizontal use for edges with a radius of
r>=0.5mm / Type A (according to European specification sheet 11.060). They are certified for horizontal use with a special webbing
lanyard, part number FA 40 304 15, connected between the reel and the user's harness.
To be used in horizontal condition, the anchorage point must be located at the same level as the edge, where the risk of fall exists. In order to
avoid pendulum effects, the working area must not exceed a 30° angle limit, from each side of the vertical of the anchorage point.
We also recommend that you do not suddenly let go of the cable when it is rolled out; it is better to keep a hand on it as it reels into the
retractable fall arrester.
Before and during use, we recommend that you take all the necessary precautions for a safe rescue should it be needed.
This equipment is for the sole use of people trained, skilled and in good health, or under the supervision of a trained and skilled person. Warning!
Certain medical conditions may affect user safety; if in doubt, consult your doctor.
Before using, always check that the locking system is in working order and that the fall indicator is not triggered (if there is one on the connector).
In case of doubt regarding the condition of the equipment (traces of oxidation) or after a fall (deformation), do not use it and/or return it to the
manufacturer or a competent person authorised by the manufacturer.
Do not remove, add or replace any component of the product.
Chemical products: put the system out of use if it comes into contact with chemical products, solvents or fuels which could affect its working.
TECHNICAL DATA:
Cable diameter: 4,5 mm - Material: galvanized steel – breaking point > 12 KN
Webbing: 25 mm – Material: polyester – breaking point > 15 KN
SUITABILITY FOR USE:
The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363). A fall arrest harness (EN361) is the only
body gripping device that may be used. It may be dangerous to create one's own fall arrest system where each safety function can interfere with
another safety function. Therefore, it is important to read the recommendations on using each component in the system before use.
VERIFICATION:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorized by
KRATOS SAFETY), but it may be increased or reduced according to use and/or the results of the annual inspections. The equipment should be
inspected if there is any doubt, or following a fall and at least annually, by the manufacturer or a competent person authorised by the manufacturer
to check its strength and hence the user's safety.
The product data sheet should be completed after each annual product verification.
SERVICING AND STORAGE: (Comply strictly with these instructions)
During transport, keep the product in its packaging, well away from any cutting surface; clean it with water, wipe it with a rag and hang it up in a
well-ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components that have
become damp during use. The system must be stored in its packaging in a dry, well aired place protected from extremes of temperature.
6
GB