Multiplex WBK10X Mode D'emploi page 4

INSTALLING TO A SUPPORT STAND
NOTE: This water booster pump can either be mounted
to the side or on the inside of the support stand. The
method of mounting is the same for either application. The
following instructions cover the side mounting. This stand
is factory assembled to mount the water booster pump on
the left-hand side of the support stand. However, the water
booster can be mounted on the right-hand side by moving
the channel to that side.
,
If the system has a plate style water filter, it MUST be
mounted to the right-hand side.
1. Locate the mounting hardware supplied with the
support stand: three (3) 1/4"-20 x 1/2" carriage bolts,
two (2) 1/4"-20 x 1/2" hex screws (not supplied), five
(5) 1/4"-20 locking nuts, and the J-channel mounting
plate, (supplied with the water booster). The J-channel
mounting plate will later be mounted to the water
booster pump.
2. With the hook end of the J-channel towards the floor,
mount the channel to the top portion on the side of
the stand.
3. Fasten the channel with three (3) 1/4"-20 x 1/2" carriage
bolts and 1/4"-20 locking nuts. Tighten all bolts
completely.
4. By lifting the back edge of the panel above the channel
and hooking it on the lower edge of the J-channel,
place the water booster pump panel on the J-channel.
5. Attach the lower edge of the water booster pump
panel to the channel on the support stand with two
(2) 1/4"-20 x 1/2" hex screws and 1/4"-20 locking nuts.
Tighten the screws and nuts completely.
6. Complete the remaining installation using the
instructions supplied with the water booster pump.
NOTE: Installer must fit/install a back flow prevention device
compliant with local water regulations in incoming water
supply line.
4 of 32
Part Number 020006830 04/23/2018
Caution
Subject: Installation Procedure Model WBK10X Water Booster Pump
J-Channel
Mounting
Bracket
Booster
Splash Guard
Model WBK10X
Water Booster
Pump
Mounting Screws & Nuts
(supplied with support stand)
BEFORE INSTALLING THE WATER BOOSTER PUMP
Incoming
Water
Supply
Coarse Filter
Filter
AFTER INSTALLING THE WATER BOOSTER PUMP
Incoming
Water
Supply
Backflow
Preventer
Water
Coarse
Booster
Filter
Pump
Figure 3
Accumulator Tank
(optional)
Beverage Unit
Regulator
0.379 MPa
(3.79 bar)
(55 psi)
Figure 4
Accumulator Tank
(optional)
Beverage Unit
Regulator
0.379 MPa
Filter
(3.79 bar)
(55 psi)
Figure 5
Multiplex
Support
Stand
To
Dispenser
To
Dispenser