Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
1. Fill the air cooler with water:
There is 2 ways to fill the air cooler with water:
1- There is a water filling spout on the back side of the tank, you can connect it
to the main source of water, and the water will stop automatically when the tank is
filled because there is a sensor that stops filling the tank.
2- Fill the tank with water manually through the water inlet cover on the back side
or directly by filling the upper tank.
Note: Only use clean tap water and do not fill the water beyond the maximum water level.
Note: When filling through the upper tank, please avoid water reaching the control panel.
2. Connect the appliance to the mains.
3. Make sure that the appliance is placed on a flat surface so that the water reaches
regularly to all sides.
4. Turn the power switch knob on the desired speed 1, 2 or 3.
5. Turn on the cooling mode by pressing the cold mode button.
6. Press the swing button to distribute the air.
- The front fan blades are responsible for distributing the air down and up and are
manually adjusted.
- The inner fan blades are responsible for distributing the air right and left and it is
operated by pressing the swing button.
7. The cooling process depends on the continuity of water in the water tank, so it is
preferable to connect a permanent water source to the appliance or fill the device
with water every 12 hours.
NB : -
The air cooler has a specific environment through which it gives the best performance,
which is the hot dry desert climate without placing it in any closed place. If the air cooler
is placed in a hot dry climate, near an open door or window to renew the air or in an
open place such as parks, cafes, restaurants and mosques, events houses and homes,
you will get cold air with minimal energy consumption.
6 Instruction Manual
Publicité
