Publicité
Les langues disponibles
Les langues disponibles
Press the DOWN [∇] button for a few seconds to start the automatic frequency search; once the
frequency has been selected, press the [SET] button briefly to valide the frequency, and second press
for synchronize the transmitter with the receiver. When the receiver light is green, automatic
synchronization is complete.
To select a frequency manually, press the "UP" [∆] button and hold for a few seconds. When the
frequency flashes on the display, press "UP" [∆] or "DOWN" [∇], repeatedly until the desired
frequency is shown. Then make a short press on the [SET] button to confirm the frequency, then a
second press to pair the transmitter with the receiver. The receiver will validate the operation by
indicating the UHF reception level of the bodypack.
For DSP Duo models with two M850 microphones or two B210 bodypacks you should carry out the
same procedure for each microphone or bodypack to synchronize them.
CAUTION, once you have synchronized one microphone or bodypack you MUST switch it off before
synchronizing the other.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Page 19
Copyright © 2022 IPE Music/Prodipe
Publicité
