Beper VE.201H Manuel D'instructions page 10

All manuals and user guides at all-guides.com
Table Fan Use instructions
PRODUCT AND ACCESSORIES Fig.1
1 – Base
2 – Column
3 – Inclination button
4 – Body motor
5 – Swing button
6 – Motor
7 – Rear grid
8 – Closure nut
9 – Rear grid nut
10 – Blades
11 – Nut blades
12 – Front grid
13 – Speed selector
14 – Supply cord
USE INSTRUCTION
FAN ASSEMBLY
1 – Place the base (1) of the fan on a stable and flat surface (ex. table).
2 – Insert the column (2) into the apposite space and fix it to the base (1) using with the provided
screws.
Important: strongly screw the screws to the base to guarantee a good stability of the fan, otherwise
it could dangerously swing.
3 – Place the rear grid (7) on the motor (4), so that the holes of the grid are embedded with the stems
located on the body of the fan motor.
4 – Strongly screw the rear grid nut (9) to block the grid on the motor.
5 – Insert the blades (10) on the motor (6).
6 – Completely screw the nut blades (11) turning anticlockwise to block the blades.
7 – Put the two grids in contact together – front (12) and rear (7) – and insert the closure nuts (8),
on the front grid (12), and rear grid (7).
USING
After assembly, check that the speed selector (13) are not pressed. Plug the supply cord (14) to the
supply power.
Press the button corresponding to the desired speed to switch on the fan.
SPEED
Select the speed by pressing the speed selector (13).
Press 0 the fan switch off.
Press 1 low speed.
Press 2 medium speed.
Press 3 high speed.
10