Sunred GS15 Manuel page 4

wheels should be removed for safety purposes.
WARNING: This heater is not equipped with a device to control the room temperature. Do not use this heater in small
rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision
is provided.
The heater is to be installed so that switches and other controls cannot be touched by a person in the bath or shower.
Operation
Connect the power cable to a 13 amp supply that is located in a safe, dry area.

The switch on the heater head is used to control the heat settings. (I) for 2100W – (0) for OFF.

Although the patio heater is weather proof, do not use when raining or in wet conditions.

Always disconnect the power cable from the electrical supply when the patio heater is not in use.
Care and maintenance

When disconnected from the electrical supply, clean the surface of the patio heater with a damp cloth. Never
use corrosive or solvent cleaners or immerse in water.

Any maintenance or repairs including replacing the halogen tube should only be carried out by a qualified
electrician or by a recommended service center.
Technical specification
•
Power supply 220V-240V ~ 50Hz
•
Wattage max 2100W
•
Net weight 10.1kg
•
Insulation class I
•
Height max 208 cm
Assembly
Step 1: Connect the Bottom Tube to the Base by screwing them together.
Step 2: Feed the Power Cord through the Base and the Bottom Tube, and pull through around 3 meters of cable.
Step 3: Connect the two Middle Tubes with the Bottom Tube by screwing them together.
Step 4: Connect the Top Tube with the Middle Tube by screwing them together.
Step 5: Place the power cord plug through base, Bottom Tube, Middle Tubes and Top Tube. Connect the power cord
www.sunred.nl