Husqvarna CTH 184T Manuel D'instructions page 25

TO ADJUST BAGGER ASSEMBLY (if needed)
HORIZONTAL ADJUSTMENT
The tractor comes from the factory with the bagger assembly preset
in a fixed position. If necessary, this position can be adjusted to
maintain a consistent gap (A) between the fender and the bag-
ger assembly top. An ideal gap is approximately 0.25" (6 mm).
• Insert 1/2" (13mm) wrench under bagger assembly top (1).
Do NOT remove; ONLY loosen adjustment bolt (2). Repeat
on opposite side.
• Slide bagger assembly into proper position.
2
• Once bagger assembly is in proper position, tighten adjust-
ment bolts (2) on both sides to 100 In-Lbs/11,2 Nm. Do NOT
overtighten.
• Readjust if necessary.
VERTICAL ADJUSTMENT
If necessary, the vertical position of the bagger assembly can be
adjusted to maintain proper alignment (B) between the fender
and the bagger assembly top.
• Remove bagger assembly.
• Do NOT remove nuts (3); ONLY loosen nuts (3).
• Raise or lower the bagger support brackets (4) to proper
position and retighten nuts (3).
4
• Replace bagger assembly onto bagger supports (4).
• Readjust if necessary.
1
1
3
25
2