Husqvarna CTH 184T Manuel D'instructions page 24

2
• Use the spacers (22) to the outside of the actuator (23) for
proper alignment. Secure with 2-3/8" clevis pin (24) and
1.35" clevis pin (25) clips (26).
26
• Connect the actuator cables (27) to wire harness (28) on the
backplate.
• Route the cable assembly along the support brackets
placing the clip (29) on the cable assembly through the hole
in the mid bracket as shown. Secure any excess cable to the
actuator bracket with the zip ties.
27
• Install the bagger assembly.
NOTE: Both cross tubes (30) on the bagger support weldment
need to be placed onto the top support assemblies (31). Extend-
ing the actuator slightly will help make installation easier. Once
installed, adjust bagger assembly as needed. (See "To Adjust
Bagger" in this section of the manual.)
30
22
24
23
25
29
28
31
TO INSTALL BAGGER SPRING LATCH
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
Before installing, tractor engine must be shut off and parking
brake engaged.
• Install each bagger spring latch with the loop end (2) down
and facing towards the bagger assembly.
• Place the mounting bolt (3) through the backplate. Place
curved end of the bagger spring latch onto mounting bolt (3)
and secure with nut (4) as shown. Tighten firmly.
4
2
1
BAGGER SPRING LATCH ADJUSTMENT
If the bagger assembly height is adjusted, it may be necessary
to adjust the bagger spring latch. To adjust, remove the nut (4)
and move the bagger spring latch to the appropriate hole in the
backplate (1), ensuring the bagger assembly will be securely
closed. Retighten nut securely.
NOTE: The bottom of the bagger assembly should contact the
loop end so that it is held securely when closed.
TO INSTALL BAGGER FULL LEVER/EXTENSION
Before installation or adjusting, tractor engine must be shut off
and parking brake engaged.
• Remove center discharge chute. (See "To Remove Center
Chute" in section 6 of this manual.)
• Remove bolt (1) from chassis. Place cover (2) in slots (3)
in backplate. While holding cover in place, place lever (4)
through slot and reinstall bolt (1). Adjust as needed.
1
3
TO ADJUST BAGGER FULL LEVER/EXTENSION
Slide bagger full extension (4) to the desired position.
• For the heaviest/wet grasses, slide extension all the way in.
• For the lightest/driest grasses, pull extension all the way out.
24
3
1
2
4