Beurer 68401 Mode D'emploi page 25

Display and buttons
5 4
1
6. Usage
Removing the table fan
1. Open the cardboard packaging.
2. Remove the table fan from the cardboard packaging.
3. Remove all plastic films.
4. Check the table fan and cable for damage. If you notice damage, contact Customer Services
at www.beurer.com.
Setting up the table fan
Important
1. Place the table fan on a firm and level surface to prevent vibrations and noise.
2. For an optimum cooling effect, place the table fan in your immediate surroundings. Make sure
that there is a clearance of at least 15 cm on all sides around the table fan. Make sure that
the air inlet and air outlet are never blocked.
Warning
To avoid the overflow of liquid, never move the table fan during operation or when
there is water in the water basin.
3
1 ON/OFF button
To switch the device on/off
2 FAN button
For setting the speed of the fan
3 FAN indicator
1 =
2 =
3 =
4 FILTER indicator
If the FILTER indicator is illuminated, it
means you must replace the evaporation
filter
5 ON/OFF indicator
2
If the ON/OFF indicator is illuminated, it
means the table fan is switched on
24
low speed
medium speed
high speed