Ryobi RY130PWA Mode D'emploi page 5

■
Keep a minimum distance of 30 cm when
cleaning vehicles. The high pressure jet
may damage or burst vehicle tires and/or
tire valves.
■
Use a garden hose with a maximum length
of 15 m and minimum diameter of 18 mm
(3/4 in).
■
Before each use, ensure that the accessory
is securely attached to the trigger gun.
OVERLOAD PROTECTION
The product has an overload protection device
that is activated when overheating or when a
current spike occurs, automatically shutting
down the power within the product. To resume
operation, disconnect the product from the
power supply, wait for about 15 minutes, and
reconnect the product to the power supply.
TRANSPORTATION AND STORAGE
CAUTION! Mind the weight of the product
when selecting the storage location and during
transportation to prevent accidents or injuries.
■
Stop the product, disconnect from the power
supply, and allow the product to cool down.
Disconnect the product from the water
supply before storing or transporting. Never
place the product in any position other than
upright.
■
Clean all foreign materials from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep
the product away from corrosive agents
such as garden chemicals and de-icing
salts. Do not store the product outdoors.
■
Remove water from all hoses and the pump,
and empty the detergent tank before storing
the product.
■
For transportation in a vehicle, secure the
product against movement or falling to
prevent injury to persons or damage to the
product.
■
Store the product indoor only. Storing the
product in an area with temperature below
0°C will damage the product.
MAINTENANCE
■
Use only original
replacement parts,
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
manufacturer's
accessories, and
■
Servicing requires
knowledge and should be performed only by a
qualified service technician. Have the product
serviced by an authorised service centre only.
■
Turn off the product, and disconnect the
plug from the power outlet. Disconnect the
product from the water supply. Allow the
product to cool down:
●
before servicing
●
before clearing a blockage
●
before checking, cleaning, or working on
the product
■
You may make adjustments or repairs
described in this manual. For other repairs,
contact an authorised service centre.
■
Regularly inspect and maintain the high
pressure cleaner for safe operation. RYOBI
recommends inspecting the product every
6 months.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure that the
product is in safe working condition. Any part
that is damaged should be properly repaired or
replaced by an authorised service centre.
KNOW YOUR PRODUCT
See page 147.
1. Carry handle
2. Hose hanger
3. Water inlet filter
4. Handle screws
5. Operator's manual
6. Nozzle cleaning tool
7. Lance hook
8. Power cord holder
9. On/off switch
10. Fixed brush
11. Brush adapter
12. Power cord
13. Water inlet port
14. Detergent tank cap
15. Detergent tank
16. Wheel
17. Hose release button
18. Water outlet port
19. Trigger handle holder
20. Spray angle
21. Spray angle lock button
22. Trigger handle lock
23. Trigger
24. Hose lock button
25. High pressure hose
26. Turbo lance
27. Vario lance
extreme care and
5
Original Instructions
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR