Publicité
Les langues disponibles
Les langues disponibles
It is advisable to check that the WiFi signal received by the camera is higher than or
equal to 60.
7.
Disconnect the network cable from the camera to switch it to WiFi mode. Press the
"
Refresh List
again when it is connected to the WiFi network.
8.
It is advisable to assign a static IP address to the camera: see section 3.3 of this
guide to perform this operation.
9.
After having installed the camera in the desired point, if it provided with autofocus
motorised lens, adjust the zoom level on the LIVE web page of the page.
4.2
MODE ACCESS POINT WIFI CONFIGURATION
This mode is used to configure the wireless network interface of the camera without wiring it to
the network. It is an alternative to section 3.1.
The camera is automatically set to Access Point mode if it was never configured in a WiFi
network.
A
PC
In this case, network configuration may be performed after having fitted and powered the camera
in its final position.
The following steps must be performed for configuration:
1.
Search from the available WiFi networks on the PC. The camera has a
"
URM_MacAddress
2.
Run steps from 1 to 6 described above in section 3.1.
3.
When the camera connects to the configured WiFi, it stops working in Access Point
mode and disconnects from the PC. For this reason, the PC must be connected to
12
"
(Aggiorna) button of
with
wireless
"
SSID. Select this SSID to connect the PC to the camera.
"
"
EasyTool
network
board
to check that the camera appears
is
needed
to
configure
it.
DS1093-556
Publicité
