Batavia FIXXPACK 12 V BT-CLC009 Mode D'emploi page 9

64222-7064223-Charger-Ma-2203-07.indb 9 64222-7064223-Charger-Ma-2203-07.indb 9
Insert the battery (1) into the machine, push the battery
•
further forward until it clicks into place.
Note: Make sure the battery and machine are lined up cor-
rectly. If the battery does not slide onto the machine easily,
don't force it. Instead, remove the battery; check the top of
battery and the machine slot are clean and undamaged and
that the contacts are not bent.
Charging the Battery
2.5
(See Fig. B).
WARNING: Failure to follow the correct procedure when
charging batteries will result in permanent damage.
a. Plug the charger plug into an electrical outlet. The green
LED indicator (4) on the charger (3) will lighten up.
b. Slide a battery (1) onto the battery charger (3).
c. Once charging commences, the red LED (5) will
illuminate.
d. When the battery is fully charged, the green LED (4) will
illuminate.
Note: Make sure the battery and battery charger are lined up
correctly. If the battery does not slide onto the battery
charger easily, don't force it. Instead, remove the battery;
check the top of battery and the battery charger slot are
clean and undamaged and that the contacts are not bent.
IMPORTANT: When a low charge level is indicated be aware
the tool may stop operating while using the tool. In some
instances this may be dangerous. It is recommended to
always ensure the battery pack has a good charge level.
Notes about Battery Charging
2.6
• Let a hot battery cool down before charging it.
• The battery should be charged at ambient temperatures
between 10 °C and 40 °C (ideally around 20 °C).
• After charging, allow 15 minutes for the battery to cool
before use.
English
9
10-03-2022 15:0 10-03-2022 15:0