Onkyo DP-S1 Mode D'emploi page 55

> Before Start > Part Names
USB Output
1
OTG Cable
You can connect a headphone amplifier or
D/A converter, for example, that has a USB
connector. You will need a USB OTG (On-
The-Go) cable (commercially available) to
connect to this unit. Make sure you have
the correct type of USB cable for the USB
port of the device you are connecting to the
OTG cable. If it is a micro USB port, you
can use the USB cable included with this
unit.
This unit is compatible with the following
devices. (As of December 2017)
Headphone amplifier : XPA-700, DAC-
HA300
0 If the attached USB-DAC does not
support DoP stream, playback and
attached devices may be adversely
affected.
Connecting a device
1. Connect this unit to the device you are
connecting using an OTG cable, etc.
Make sure you plug the cable in the right
way up when connecting. You may
20
> Initial Setup
damage the plug or jack if you try to
insert it the wrong way.
2. Turn on the power of this unit and the
connected device. " " is displayed on
the status bar on the screen when this
unit recognizes the connected device.
0 When playing DSD format music files,
DoP format can be output via USB
(P22).
> Playback
2
Library
Online
Line
Balanced
Out
Advanced Setup | Supplementary Information | Others