Power Dynamics WT10 Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (fuse).
INSTALLATION
1. Connect your active speaker (set) or amplifier correctly with the output terminal of the WT10 Wifi module by supplied
line-in cable.
2. Use the supplied USB cable to power the module. Use the USB slot (A) to power the module by mains supply, use the
5V entry (B) to power the module by for example a power bank. The USB slot (A) is also usable for playing your tunes
directly from a USB-drive.
3. Download the free MUZO app from the App Store or Play Store and connect your music device by following the direct
instructions from there.
3