Orbegozo FH 5021 Manuel D'instructions page 15

FH 5021 FH 5022 FH 5025 FH 5026 FH 5036
Oscillation (FH 5022 – FH 5025)
With the rocker switch you can switch on or off the oscillation of the fan heater. The oscillation
function can be operated to every function separately.
Control lamp:
The control lamp indicates the operation if st
thermostat switch.
The control lamp shines so long, since the thermostat switches off the device with reaching of the

opposed ambient temperature and begins again if the thermostat again turns on the device.
If the steps switch turned on position

lamp goes out.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the
power as soon as the heating elements become too hot.
MAINTENANCE
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
Set the selector switch to position
-
Wait for the heater to cool down sufficiently.
You may clean the outside of the heater with a damp cloth or brush. Do not use water or allow
-
water to come into the appliance. Do not use any abrasive and caustic cleaning agents!
Never touch the heater in water! Danger to life!
-
Clean the air inlet and outlet grilles regularly with a vacuum cleaner, using the brush attachment.
-
Storage
Keep the original box in which the heater was packed to store it during the warmer months when it is
not in use. Clean the heater according to the instructions under Cleaning.
Pack the heater in the original box and store it in a cool, dry place.
TECHNICAL CHARACTERISTICS
Model: FH 5021 - FH 5022 - FH 5025 - FH 5026 – FH 5036
Voltage: 220 V – 240 V
Power: Maximum 2200 W
Tension: 50 Hz.
ep ( ) is turned on in combination with the
or the device by the electricity mains is taken, the control
to switch off. Remove the mains plug from the wall socket.
15