D-Link DCS-4633EV Guide D'installation Rapide page 13

Waterproofing Your Installation
To waterproof your camera installation, follow the instructions below. Round Ethernet
cable, a crimping tool, and RJ-45 plugs are required for this procedure.
Place the washer around the base of the Ethernet
connector as shown.
Thread bare Ethernet cable through the waterproof
connector as shown.
Crimp an RJ-45 connector onto the end of the cable.
Connect the other end of the Ethernet cable to the
camera's Ethernet port.
Connect the RJ-45 plug into the Ethernet connector, then
screw the waterproof connector to the Ethernet connector
by turning it clockwise for about a half-turn.
11
D-Link DCS-4633EV Quick Installation Guide