PUR P1QC7506BLS Manuel Du Propriétaire page 9

Initial Product Cleaning (continued):
9. To drain any remaining water from the reservoirs, unscrew the drain cap and
plug located at the rear of the dispenser (Figure 17). Collect the water into a
bucket. Flush the reservoir a second time with clean water.
IMPORTANT: Remember to re-install and tighten the drain cap and the plug.
10. Re-install the reservoir cover by pressing down firmly.
11. Re-install the dispenser top cover and secure using the two Phillips screws.
12. Re-connect the power cord.
13. Re-open the manual shut-off valve. You will hear water entering the system
which will stop automatically when the appropriate water levels are reached.
14. Place a container under the water spigots and press both dispensing buttons
(separately) to make sure water is flowing normally from each side.
Operation Instructions:
IMPORTANT NOTE: Your PUR
mechanism) that controls the operation of the Kettle Feature hot water tank heating system.
If no water is present and/or low water levels are detected inside the internal reservoir system, operation of the hot water heating
system is not possible. Likewise, if the hot water heating is operational and water is being drawn simultaneously causing water levels
to drop below safe levels, hot water tank operation is automatically terminated until normal water levels are restored, at which time
you must "manually" re-activate the hot water heating system by pressing the Kettle Feature (red) button (Figure 20).
NOTE: Operation of the cold water system is not affected by this safety feature.
Child Resistant Safety Switch (See Figure 18 & 19):
CAUTION: Do not allow children to use the hot water dispensing button
without proper and direct supervision.
To prevent hot water from being dispensed accidentally and possibly harming a child,
the hot water dispensing button can only be operated when the child resistant safety
switch is activated. To dispense hot water, slide the child safety switch sideways and
hold (in the direction of the arrow located on the switch) from right to left (Figure 18),
then press/hold the hot water button (Figure 19). As soon as water starts flowing
you can release the child safety switch until the desired amount of hot water is
dispensed. Upon releasing the hot water button, the child safety switch automatically
re-engages to the locked position.
Water Dispenser is designed with a special safety feature (float switch
®
Figure 16
Figure 17
Figure 18
Figure 19
8