Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions (continued):
8. The Water Dispenser is equipped with a Manual Shut-Off Valve installed on the rear of
the unit (Figure 6) for easy access in case of an emergency. Remove sanitation plug
from the Shut-Off valve before installing the water line (Figure 7).
9. Connect the incoming water line into the open side of the Manual Shut-Off Valve
(Figure 6). This valve utilizes Quick-Connect Fittings, for which no tools are required.
Simply insert the end of the Tubing firmly into the Manual Shut-Off Valve until it
comes to a complete stop (approx. 1/4") (Figure 8).
WARNING: DO NOT OPEN THE COLD WATER SUPPLY VALVE AT THIS STAGE.
(See Installation of Filter)
To disconnect the Tubing from the Manual Shut-Off Valve, you must first remove the Blue
"Horseshoe C-Clip" from the Quick-Connect Fitting (Figure 9). Then push in the Collet and
pull out the Tubing to remove it from the Manual Shut-Off Valve (Figure 7).
NOTE: The Blue "Horseshoe C-Clip" must always be installed PRIOR to
installation of the water lines.
Filter Installation (See Figure 10 & 11):
The Filter inside the Water Dispenser has not been factory installed. It has been shipped
in its original shrink-wrapped packaging for sanitation purposes.
The Filter is located behind the Lower Front Panel of the Dispenser. Follow these steps to
access/install the Filters:
1. Pull out the Drip Tray and then remove the Phillips Screw securing the Lower Panel.
Remove the Lower Panel from the Dispenser (Figure 10).
2. Remove the Filter from the Retaining Clip, and remove the shrink-wrap.
3. Check that the Red Locking Tab (filter head) is positioned to the left "Unlock" position
(Figure 11).
4. Insert the Filter into the Filter Head and give it a 1/4 turn clockwise until it stops and
the dots are properly aligned. Push the Red Locking Tab to the right "Locked" position
(Figure 11). If the Red Locking Tab fails to engage (lock), the Filter is not sufficiently
aligned. Make sure the dots on the filter head and filter are properly installed/aligned.
NOTE: The internal water connection lines to the Filter Head are factory
installed.
The installation is now complete. Slowly open the Shut-Off Valve. Check all connections
for leaks prior to opening all water valves fully. If any leaks are detected, immediately
turn off the water supply and repair. Re-install the lower front panel and secure with
Phillips screw and then re-install the drip tray (Figure 10).
Figure 7
Sanitation Plug
Figure 8
Backstop
Full engagement length
Figure 9
Collet
Horseshoe Clip
Figure 10
Figure 11
45˚
O-Ring
1/4
6
Publicité
