Orbegozo KT 5010 Manuel D'instructions page 13

KT 5010
• Do not fill with less than 0.5 liters of water（to "min" indication）to prevent the kettle running
dry while operating．
• Do not fill with more than 1.0 liters of water（to "max" indication).
• An automatic safety cut-out has been fitted for protection against overheating，it will operate
if the kettle is switched on when containing insufficient water．Always ensure the water inside
the kettle covers the minimum mark on the water level indicator gauge．If the automatic
safety cut-out has operated，switch the kettle off，disconnect from the power outlet and
allow the kettle to cool down for 5 to 10 minutes．The refill with and switch on，the kettle
will work as normal.
KETTLE
• Place the power base on a dry, flat surface. Place the kettle on the power base. The electrical
connection will be made automatically as the kettle slides onto the power base. Plug the cord
set on the power base. The electrical connection will be made automatically as the kettle slides
onto the base.
• Plug the cord set into an earthed power socket and switch on by depressing the switch of the
kettle to the "on" position.
• When the water has boiled, the kettle will switch off automatically, after allowing the kettle to
cool down for 1 minute, the water can be brought back to the boil by pushing the switch back
to the "on" position. During the cooling down time do not force the on/off switch into the
"on" position as this can damage the operating mechanism.
• Do not remove the kettle from the power base without switching off first.
• Remember, if you do not wish to re-boil the kettle, switch it off.
• The kettle may be switched off manually at any time by setting the on/off switch into the "off"
position.
• To pour water, lift the kettle from the power base and pour.
HOW TO CARE FOR YOUR KETTLE
• Wipe the exterior of the kettle with a soft, damp cloth or sponge. Remove stubborn spots with
a cloth moistened with mild liquid detergent. Do not use abrasive scouring pads or powers.
• Never immerse the kettle in water or other liquids.
• From time to time, depended on the nature of your water supply, a boiled scale deposit is
naturally formed and can be found mostly adhered to the heating element, thus reducing the
heating efficiency.
• The amount of boiled scale deposited (and subsequently the need to clean or rescale) largely
depends on the water hardness in your area the frequency with which the kettle is used.
• Boiled scale is not harmful to your health. But if poured into your beverage, it can give a
powdery taste to your drink. Therefore, the kettle should be descaled periodically as indicated
below.
DESCALING
13