Publicité
Les langues disponibles
Les langues disponibles
FIXING THE DECORATIVE TELESCOPIC FLUE
Arrange the electrical power supply within the dimensions of the
decorative flue. If your appliance is to be installed in the ducting
version or in the version with external motor, prepare the air exhaust
opening. Adjust the width of the support bracket of the upper flue
(Fig.3). Then fix it to the ceiling using the screws A (Fig.2) make sure
that it is in line with your hood and respecting the distance from the
ceiling indicated in Fig.2. Connect the flange C to the air exhaust hole
using a connection pipe (Fig.4).
FILTERING VERSION
Install the hood and the two flues as described in the paragraph
for installation of the hood in ducting version. To assemble the
filtering flue refers to the instructions contained in the kit. If the
kit is not provided, please order it from your dealer. The charcoal
filters must be fitted in the ducting unit located inside the hood.
Control panel
If your appliance does not have the INTENSIVE speed function, press
key A for two seconds and it will be activated for 15 minutes after
which it will return to the previously set speed. If the function
program of the unit is active the LED will flash.
By pressing any key except the key for the light, the hood will return
immediately to its normal functioning.
FUNCTION KEYS:
A = OFF
B = SPEED I / OFF
C = SPEED II / OFF
D = SPEED III / OFF
E = LIGHT
7
V.2
Publicité
