Conrad 41 36 11 Mode D'emploi page 4

Tips & notes
a) USB2.0
• USB2.0 devices are backwards compatible. This means that the hard disk enclosure with the
inserted SATA hard disk also functions when connected to common USB1.1 ports - but then
only at the maximal USB1.1 speed (effectively, ca. 1MBytes/s; up to 35MBytes/s are possible
with USB2.0 depending on the USB controller).
• If you want to connect the hard disk enclosure via a USB hub, the latter must also support the
USB2.0 transfer mode, in order to achieve the maximum speed.
b) General
• The power LED lights up, when the hard disk enclosure is switched on and supplied with
power. The access LED flashes during read/write access.
• USB devices can be connected and disconnected during operation.
You should, however, take into account that data may be corrupted or the operating system
may crash if the connection cable is disconnected while data are being transferred.
In Windows, an arrow symbol is displayed in the menu bar when the hard disk (or other USB
devices) is in operation. Click this arrow symbol to „separate" the device, i.e. to terminate data
transmission, so you can disconnect the connection cable without risking losing data.
Disposal
Electrical and electronic products do not belong in the household waste!
When disposing of an unserviceable product, do so in line with the relevant statutory
regulations.
Technical data
a) Hard disk enclosure
Connection: ..........................................USB2.0
Suitable hard disk for installation: ........SATA, 8.89cm/3.5"
Dimensions (L x W x H): ......................approx. 208 x 128 x 36mm (without foot/rubber feet)
b) Power supply unit
Operating voltage: ................................100-240V~, 50/60Hz
Output:..................................................12V= 2A
All manuals and user guides at all-guides.com
© Copyright 2010 by Conrad Electronic SE.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.