Tripp-Lite Protect It! SK10USB Manuel Du Propriétaire page 2

Important Safety Instructions
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension
cords or adapters. This surge protector is designed for indoor use only. Install the surge
protector away from heat-emitting appliances such as radiators or heat registers. Do not
install where excessive moisture is present. Do not plug extension cords into it. Never install
electrical, telephone, network or coaxial wiring during a lightning storm. Do not drill into any
part of the housing or open the housing for any reason. There are no user-serviceable parts
inside.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
Installation
Connect Your Surge Protector to the AC Power Line: Plug the surge protector directly into a
3-wire grounded, 120V AC outlet.
Secure Surge Protector to Outlet Using Included Mounting Screw (SK30USB, SK34USBB
and SK40RUSBB only): Securing the surge protector to the outlet will prevent accidental
disconnection. Remove the wall outlet cover plate and plug in surge protector. Screw in the
included mounting screw to attach the surge protector to the outlet.
Check Your Surge Protector's Diagnostic Indicator Lights: If your surge protector features
diagnostic LEDs or indicators, check them prior to connecting your equipment. They will indicate
various operating conditions when the surge protector is plugged into a live 120V AC outlet.
"PROTECTED" LED: Indicates the surge suppression components are intact and providing
complete protection against surges. If this LED does not illuminate, some of the surge
suppression components are not functioning, and the unit should be replaced.
Visit www.tripplite.com/support.
Connect Your Equipment to the Surge Protector's AC Outlets: Plug your equipment's power
cords (including 2-wire devices) into the surge protector's AC outlets. Select models feature
integrated safety covers which cover the outlets when not in use. Other models feature special
widely-spaced outlets to accommodate transformers without covering other outlets. DO NOT
plug in extension cords. DO NOT OVERLOAD the surge protector's outlets. The surge protector
can accommodate a total equipment load of up to 15 amps (whether plugged into a single
outlet or spread out over multiple outlets).
USB Charging Ports: Two USB charging ports are capable of delivering ample power to even
the most demanding devices, including smartphones, tablets and MP3 players. Total USB
charging output varies by model:
Model
SK10USB
SK30USB
SK34USBB
SK120USB
SK40RUSBB
TRAVELER3USB
16-05-289-9335E9.indb 2
Total USB
Charging Output
2.4 A
2.1 A
4 / 4.8 A
2.1 A
3.4 A
2.1 A
2
Number of
AC Outlets Cord Length
1
3
3
3
4 (Rotatable)
3
N/A
N/A
N/A
N/A
N/A
18"
5/23/2016 3:28:05 PM