Vanderbilt V44 Duo Manuel D'installation Et Utilisation page 11

V44 Duo Installation & User manual
Choose password
The first thing to do before you can start programming is to
choose a password.
1 Press and hold the SW1 button on the code lock's
circuit board. Both LEDs are lit.
2 Enter a 6-digit password.
3 Make a note of the new password in the chart at the
back of the manual.
Change password
1 Press B and enter the current password.
2 Enter A27.
3 Enter the new password. A warning tone is heard.
4 Enter the new password once again.
5 Press B to leave programming mode.
6 Make a note of the new password in the chart at the
back of the manual.
Programming commands
Always press B and the password before any commands
are used.
Leaving the programming mode can be done by pressing B.
11