Haier ES50V-F1 Manuel D'utilisation page 8

Installation Methods
Figure 1 Installation Schematic - Vertical Installation
(F1/TF7/VH3 Series)
Hot water
Cold water
valve
valve
Figure 4 Installation Schematic - Horizontal Installation(for TF7 Series only)
It must be installed according to the schematic
Hot water outlet
Hot water
valve
Cold water
valve
It must be installed by the installer belonging to the After-sales Service Department of our company
or by its designated installer. For the installation of the water heater by personnel not recognized
by our company or the use of self-provided installation materials, which results in the
consequences, including but not limited to pipeline leakage, crash, poor installation affecting the
normal operation and performance of the water heater, and adverse effects or damage to the body
of the water heater. The company will not be responsible for any losses incurred as a result.
The water heater uses wall-mounted installation.
For the F1 Serie, the installation method is as follows:
Refer to Figure 1 of the Installation Schematic, and drill four holes in the wall using an percussion
1.
drill to match the accessory expansion hook according to the dimensions shown in Figure 2 and
the table below.
Model
2. Insert the expansion bolts into the wall-mounting frame first, then fix them together in the wall
holes, and finally hang the water heater onto the wall-mounting frame.
3. Install the safety valve and other accessories with reference to the "Installation of Safety Valve"
(for installation reference only). Be careful to add thread seal tape seal to prevent water leakage.
8
Hot water outlet
Cold water inlet
Nozzle
Water mixing
valve
Cold water inlet
Nozzle
Water mixing
valve
ES50V-F1(EU) ES80V-F1(EU)
a 170 mm
b 88 mm
c 362 mm
Safety valve
Safety valve
Model
ES100V-F1(EU)
170 mm
88 mm
635 mm
360mm
TF7 Serie
190mm
270mm
VH3 Serie
ES50V-TF7(EU)
f1
297mm
170 mm
88 mm
851 mm
Figure 2
Figure 3
f1
ES80V-TF7(EU)
622mm
Figure 5