Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTENANCE WARNINGS
Turn off the device and disconnect the power before cleaning. Failure to do so can cause electrical
•
shock.
Do not clean the air conditioner with excessive amounts of water.
•
Do not clean the air conditioner with combustible cleaning agents. Combustible cleaning agents
•
can cause fire or deformation.
Make sure that water condensation can drain unhindered from the unit.
operate the air conditioner with wet hands. This may cause electric shock.
use device for any other purpose than its intended use.
climb onto or place objects on top of the outdoor unit.
or if the humidity is very high.
injury. Take care while handling this equipment and wear gloves and protective clothing.
WARNINGS FOR PRODUCT INSTALLATION
•
Installation must be performed by an authorized dealer or specialist. Defective installation can cause water
leakage, electrical shock, or fire
•
Installation must be performed according to the installation instructions. Improper installation can cause
water leakage, electrical shock, or fire. (In North America, installation must be performed in accordance
with the requirement of NEC and CEC by authorized personnel only)
•
Contact an authorized service technician for repair or maintenance of this unit. This appliance shall be
installed in accordance with national wiring regulations.
•
Only use the included accessories, parts, and specified parts for installation. Using non-standard parts can
cause water leakage, electrical shock, fire, and can cause the unit to fail.
•
Install the unit in a firm location that can support the unit's weight. If the chosen location cannot support
the unit's weight, or the installation is not done properly, the unit may drop and cause serious injury and
damage.
•
Install drainage piping according to the instructions in this manual. Improper drainage may cause water
damage to your home and property.
•
Do not install the unit in a location that may be exposed to combustible gas leaks. If combustible gas
accumulates around the unit, it may cause fire.
•
Do not turn on the power until all work has been completed.
•
When moving or relocating the air conditioner, consult experienced service technicians for disconnection
and reinstallation of the unit.
•
Follow all safety codes. Wear safety glasses, protective clothing, and work gloves. Use quenching cloth for
brazing operations. Have fire extinguisher available.
•
Excessive Weight Hazard - Use two or more people when moving and installing the unit. Failure to do so
can result in back or other type of injury.
•
Take precautions to ensure Aluminum tubes do not come in direct contact or allow for
condensate run off with a dissimilar metal. Dissimilar metals can cause galvanic corrosion and
possible premature failure.
•
Failure to follow this caution may result in personal injury. Sheet metal parts may have
sharp edges or burrs. Use care and wear appropriate protective clothing and gloves when
handling parts.
Page 4
.
Publicité
