Publicité
Les langues disponibles
Les langues disponibles
1. Install the Drawer
IMPORTANT! If not fully engaged with the rails, the drawer can fall or be pulled out. Before completing the installation,
lift up on the drawer to ensure that the drawer is fully engaged.
Inside the vanity, locate the pre-drilled holes for the accessory drawer rails.
Orient the rail assembly as shown and align with the pre-drilled holes.
Secure the rail to the vanity with six screws.
Repeat for the rail assembly on the other side of the vanity.
Fully extend both rails.
Rest the back end of the drawer onto the rails and align the rail hooks with the drawer holes.
Rotate the front of the drawer down onto the rails, engaging the latches with the rails.
Push the drawer closed to fully snap the latches into the rails and insert the rail hooks into the drawer holes.
Lightly lift the front of the drawer to verify that it is fully engaged with both rails.
Kohler Co.
Latches
3
Hole
1470605-2-A
Publicité
