Publicité
Les langues disponibles
Les langues disponibles
(EN) ENGLISH
DGXDSDV111SMA-2KM/DGXDSDV112SMA-2KM - 2000m Digital AV Sender System
Installing your DigiSender® XD-2KM
Step 4 - Install the Receiver
The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
Please Note: It is important that both Antennas are pointed towards each other and installed in the same plane.
i.e. Both vertically or both horizontally.
1.
Install the Yagi™ 2km Antenna in the desired re-
ceiving location using the supplied pole mounting
brackets and connect the large end of the 12m
low loss cable. Connect the smaller end to the Di-
giSender® Receiver.
3. HDMI version
3.
Use the remaining HDMI cable and connect it to
the socket labelled 'HDMI OUT' on the back of the
DigiSender® Receiver and the HDMI input on your
receiving TV.
Page 08
All manuals and user guides at all-guides.com
2. SCART version
2.
Locate a vacant SCART socket on the back of your
receiving TV and connect the Receiver SCART plug.
4.
Connect the Power Supply Unit (PSU) to the socket
labelled '5V ~1.0A' on the rear of the Receiver and
plug it into an available mains socket. The Power
LED will light up Red to indicate that the unit is in
Standby Mode.
Please read the instructions carefully prior to installation
Publicité
