EGAmaster EGAtronik 51252 Manuel D'instructions page 24

Fuse specification:
F1 Fuse 0.2A/250V
F2 Fuse 10A/250V
Protective
case
Screw
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the machine
being incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed
number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones
must be collected and arranged separately. If you have to throw them out, please, do not use
the usual rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly
filled within one week after purchased the machine to the maker.
24
Φ
5x20mm ceramic tube.
Φ
5x20mm ceramic tube.
NOTES
GUARANTEE
Figure 4
Protective
case
Screw
Fuse