Publicité
Les langues disponibles
Les langues disponibles
#04648 CPBDADP and #04658 CPBDBT
DEWALT
ASSEMBLY:
®
1. Remove the battery from the grinder before any work
is to be done on the grinder.
2. Remove wax protective coating on the new router bit. The
router bit is not supplied with CPBDADP beveler adapter and
must be purchased separately.
3. Place the router bit into the grinder collet and slide the bit
down until it stops (bottoms out) and hand tighten the collet.
4. Next, raise the bit up until the unfinished shaft is just visible
above the collet. Tighten the collet with the wrenches
provided with the grinder.
5. FIRMLY TIGHTEN THE COLLET to prevent the router bit from
coming loose while operating and causing damage or injury.
6. Place the beveler adapter head #04648 onto the grinder with
the Adjusting Knob in line with the grinder's on/off switch as
shown in the Assembly Diagram 1. The rib on the grinder
handle must fit into the groove in the Adapter.
7. Loosen the Adjusting Knob and slide the Guide Plate to the
lowest position. Push down on the Adapter Head with a
rocking motion until the top of the guide plate is in line with
the bottom of the Router Bit.
8. Slide the guide plate assembly up and tighten the clamp
screw on the Adapter Head.
9. Adjust the guide plate to the desired length of bevel and
tighten the Adjusting Knob.
2
ASSEMBLY DIAGRAM 1
SHROUD
GUIDE PLATE
ADAPTER HEAD
ASSEMBLY
CLAMP SCREW
DEWALT ADAPTER
DEWALT GRINDER
04648 CPBDADP
04671 CPDMADP29
®
®
DeWalt
, Milwaukee
and Bosch
and are not associated with Reed Manufacturing.
ASSEMBLY DIAGRAM 1
04648 ASSEMBLY DIAGRAM 1
SHROUD
GUIDE PLATE
ADAPTER HEAD
ASSEMBLY
CLAMP SCREW
DEWALT ADAPTER
DEWALT GRINDER
04648 ASSEMBLY DIAGRAM 2
5/32"
APPROXIMATE
GUIDE PLATE SHOULD BE FLUSH
WITH BOTTOM OF ROUTER BIT
GROOVE IN
CPB ADAPTER
RIB ON
HANDLE
®
are registered trademarks
GUIDE PLATE SHOULD BE FLUSH
WITH BOTTOM OF ROUTER BIT
ADJUSTING
KNOB MUST BE
GROOVE IN
IN LINE WITH
CPB ADAPTER
ON/OFF SWITCH
AS SHOWN
RIB ON
HANDLE
POWER SOURCE
Brand
Grinder
Model
DeWalt
DCG426B
®
ASSEMBLY DIAGRAM 2
LOCATE ROUTER BIT SO
THE UNFINISHED AREA ON
THE SHAFT IS JUST ABOVE
TOP OF COLLET
COLLET
4
ADJUSTING
KNOB MUST BE
IN LINE WITH
ON/OFF SWITCH
AS SHOWN
4 REFERENCE LINES
1/8" INCREMENTS
FOR ADJUSTING
04648 -Adapter Plate on
THE BEVEL SIZE
DeWalt
die grinder
®
COL
Die
Uses
Adapter
Head
04648
4 REFE
1/8"
FO
TH
1/8"
0523-54654
Publicité
