Uline H-10161 Mode D'emploi page 4

CONNECTING MONITOR PLATE TO
WALL PLATE
1. With second person, carefully lift the monitor and
align the holes of the monitor plate with the wall
plate. While one person continues to hold the
monitor, attach the top M6 nut (B4) first, then the
bottom M6 nut, to secure the monitor plate to the
wall plate. (See Figure 11)
Figure 11
Monitor Plate
PAGE 4 OF 12
INSTALLATION CONTINUED
Monitor
M6 Nut
Wall Plate
M6 Nut
ADJUSTING MONITOR AND CABLE
MANAGEMENT
1. If the monitor needs to be adjusted, use the
5 x 5 mm Allen wrench to loosen and tighten the
tension screws. (See Figure 12)
2. Cables can be managed by running them through
the cable management clip that attaches to the
support bars. (See Figure 12)
Figure 12
Tension
Screw
90º
+
–
Cable
Management
Clip
1-800-295-5510
uline.com
5 x 5 mm Allen Wrench
+ 90º
–
+ 180º
–
3º
+
–
-2º–12º
0223 IH-10161