Publicité
Les langues disponibles
Les langues disponibles
Buttonholes
Make sure that the buttonhole foot is properly attached (see page 21).
Choose setting
on the stitch selector and pull the top and bobbin threads
to the left.
1. Slide the buttonhole foot forwards to measure the length of the button-
hole. Use the guidelines on the buttonhole foot. Lower the buttonhole
foot and needle. Slowly sew one side of the buttonhole until you reach
the end of the buttonhole foot. Finish with the needle in the left hand po-
sition.
2. Change the stitch setting to
dle to the right.
3. Change the stitch setting to
lines on the buttonhole foot are aligned. Finish with the needle in the
right hand position.
4. Change the stitch setting to
dle to the left.
5. When you have finished, lift the fabric and pull it about 15 cm back-
wards. Cut the threads with the thread cutter, leaving them the right
length for when you start sewing the next seam. Cut open the buttonhole
using the seam ripper.
TIP! Try sewing on a scrap of fabric first to adjust any settings if necessary
before using the "proper" fabric.
All manuals and user guides at all-guides.com
and sew a few stitches. Finish with the nee-
and sew all the way back until your guide-
and sew a few stitches. Finish with the nee-
Foot
Stich
4
1
3
2
1
3
3
2
1
4
ENGLISH
4
2
4
2
19
Publicité
