Publicité
Les langues disponibles
Les langues disponibles
EN
Prior to operation
Attaching and removing the battery
① Press the battery holder release button to pull out the battery.
② Connect the front of the battery and press the back of the battery until it snaps into place.
Caution:
Make sure you have disconnected the power cord from the plug before attaching or detaching parts and accessories.
Battery charging
Connect the device directly to the charger.
① Plug the charger into a suitable power outlet (100-240V-50/60Hz).
② If the connection has been made correctly, you will notice that the indicator lights will light up one after another, indicating charging mode status.
Charging is completed in 3.5-4 hours.
Caution:
For safety reasons, use the supplied charger or other chargers with the same technical characteristics. For optimum use of the battery capacity, it is
recommended that you carry out a full charge before initial use.
Operating Instructions
Switching the device on/off
① Empty and clean the dust collection container before each use.
② To turn on the appliance, press and hold the ON/OFF switch for 1 second.
③ To turn the appliance off, press the ON/OFF switch again.
Cleaning the device
Turn off the device and unplug the charger from the wall outlet and clean the external surfaces with a clean cloth.
Caution:
Do not expose the device to extreme weather conditions (for example, rain).
If necessary, use a clean cloth slightly dampened with water to clean the spout, filter, etc.
Make sure that the appliance does not absorb any liquid. Do not place the appliance components in a dishwasher in order to clean them.
Do not use wire sponges or similar products to clean the appliance. Do not use corrosive cleaning liquids (e.g. solvents) as they may damage the external
surfaces of the appliance.
Ensure that all components and parts are completely dry before placing them in the appliance.
Cleaning the dust cup and filter
Empty and clean the dust cap before starting the appliance. It is recommended that the container be emptied into a bag to trap the dust produced during
emptying. Make sure to disconnect the power cord from the appliance before cleaning.
① Turn off the appliance via the ON/OFF switch.
② Hold the appliance by its handle and make sure the container is facing down. The dust-block film prevents dust from leaking from inside the appliance.
Press the dust collection container release button to disconnect the container from the appliance.
③ Remove the dust collection container and empty the contents into the waste bin or a bag.
④ Gently tap the filter to loosen some of the dust, then wash the filter and container with clean water. Dry all parts thoroughly before reinstalling them.
Caution:
Cleaning of the container and filter should only be done with clean water. Do not use any cleaning agents as these materials can cause corrosion. If any of
the components are damaged, they should be replaced immediately.
The filter should be connected to the tank/spout after being cleaned and dried thoroughly.
Reinstalling the filter in the dust cup
Connect the back of the cap to the slots of the device. Press the release button and push the cap into the device until it locks properly.
3
WWW.NIKOLAOUTOOLS.GR
Publicité
