Rimax Baby Kangoo RB201 Manuel De L'utilisateur page 17


For matching with additional cameras, repeat the above process and select
Channel 3 or 4 by pressing the Channel Button (25) of the monitor.

Press the Channel Button (25) to see the images from different paired
cameras.

For deletion, press the Channel Button (25) at the back for about 3 sec. Press
this Channel Button again to select the channel to be deleted.

Use the Adjustment Button (+) (-) (17)(20) to choose "DEL". Press the Mode
Button (18). The deletion process will be completed.
Channel Scanning Function (25)
This product enables you to use up to 4 different cameras with the same monitor to
monitor different areas as you need.
Press the Channel Button (25) until
scanning function is initiated. The monitor will stay for 5 seconds with one camera
before automatically switched to the next one and repeat the cycle continuously.
To stop the scanning function, press the Channel Button (25) again to return to the
specific channel number.
LCD Screen Display
These icons can appear on the top part of the screen whenever the monitor is power
on. To see them, simply press the Talk Button (16). It will also display for a few
seconds when you press the Music Button (21).
(1) Signal Strength Indicator
(2) Channel Number Indicator
(3) Speaker Volume Level
(4) Lullaby Selection
appears on the screen. Automatic
CH1
1
1
TROUBLESHOOTING
Problem
Screen turns on and off
No reception at monitor
No picture display but can hear
sound
Batteries cannot be recharged
No transmission from camera
Possible Cause – things to do/check

The AUTO mode is selected on the camera,
when there is no noise detected by the
camera it stops transmitting to save power.
Screen then turns off.

Select the CAMERA mode on the camera to
disable this function.

Unit has not been switched on.

AC/DC adaptor has not been connected.

Adjust the position of the camera or monitor.

No battery power (check the power LED
indicator.)

The camera may not be transmitting, either
not powered ON or in AUTO mode (voice
activation.)

Wrong channel.

Check the LCD ON/OFF switch.

Low power (check the power LED indicator).

AC/DC adaptor has not been properly
connected.

Non-rechargeable battery has been used.

Only the supplied rechargeable batteries
can be recharged. Please contact your
dealer/retailer if you have any queries.

Unit has not been switched on.

AC/DC adaptor has not been properly
connected.

Check if the AUTO mode is selected on the
camera.