Maintenance; Brake Adjustment; Chain Adjustment - Beeper FX1000-S Manuel D'installation & D'utilisation

Step 4: Then lower the mast of your scooter towards the platform until it locks.
Step 5: Then re-install the safety pin in its location.

MAINTENANCE

Brake adjustment

The scooter has front and rear disc brakes, for safety, please check their operation every 3 months.
You have 2 adjustment levels:
Level 1 - Adjust the brake cable tension at the handle
Before adjusting the brake cable tension, make sure that the adjusting knob on the lever is fully screwed in.
It is a lock nut system.
Loosen the cable clamp screw, tension the cable and moderately tighten the clamp screw. You can also hold the cable
with a universal pliers or a multigrip pliers while tightening.
Now test the brake lever free play:
• The brake is too hard: loosen the clamping screw a little, then press the lever lightly, until you reach the clearance you
like. Finally tighten the clamping screw to lock the cable.
• The brake is too soft: if your brake needs a little more cable tension, use the dial to fine-tune the adjustment. Otherwise,
perform the cable tension operation again.
Level 2 - Adjust the brake cable tension at the wheel
You can adjust the cable tension at the wheel, just loosen the screw that clamps the brake cable at the wheel, retighten
the cable then retighten the screw.
Caution: The brakes may squeal, this does not affect their operation.

Chain adjustment

The chain should be aligned with the sprockets to avoid uneven wear, so it may need to be adjusted.
The chain should be adjusted if:
• She's skipping the gears, she's too loose.
To tighten the chain, re-tighten the two axle screws on each side of the wheel.
• It makes a humming noise when you turn the wheel, it's too tight.
To loosen it, reverse the operation, loosen the two axle screws located on either side of the wheel. An adjusted chain
should be slightly tensioned when the scooter is straight.
Maintenance
Check points
Tire pressure
Chain tension Every 2 months
Nuts Every 6 months
Drums Every 6 months
Brake cables
Brake adjustment Every 3 months
Usage time KM
Every month -
-
500 km
-
Once a year
-
-
Re-inflate the tires between 2.5 and 3 bars
Paragraph "Adjusting the chain"
Check each nut on the scooter and tighten them up to the stop, adding
Check your battery or wires for damage
Lubricate the brake cables with bicycle lubricant. Apply a few drops of
product to the junction of the brake cables and the cable guards at the
brake handles. Apply the brakes to distribute the product over the
entire length of the cable.
Check the braking and if necessary adjust the tension of the brake
cable Paragraph "Adjusting the brakes"
15
Handling
1/4 turn