Publicité
Les langues disponibles
Les langues disponibles
8. Setup
The charger heats up during use. Ensure that there is sufficient ventilation. Do not cover the housing!
Never charge lead batteries in a closed container.
Ensure there is sufficient ventilation during the charging process and avoid naked flames!
Explosive gases may be generated during the charging process. Keep the charger out of the reach of
children!
Before charging batteries with liquid acid, open the sealing plugs on each cell.
Leave the battery casing to ventilate for approx. 2 minutes to allow explosive gases to evaporate!
Check the liquid level and top up if necessary.
Check the liquid level on a regular basis during longer charging periods (overwintering). Wear safety gog-
gles when inspecting the batteries!
Do not turn lead-acid batteries upside down. Avoid any contact with the battery liquid, as it may cause
severe chemical burns.
Rinse the contact points (skin, clothes etc.) immediately with water to dilute the battery acid.
Contact a doctor immediately in case of contact with skin.
In case of prolonged storage, charge lead-acid batteries every 3 months to prevent them from draining.
Never short-circuit the battery contacts.
When connecting batteries, ensure that they are connected in the correct polarity and observe the charging
instructions provided by the battery manufacturer.
a) Charging a battery
• Ensure that your battery is compatible with the charger. It must be a 6 V / 12 V lead-acid, lead-fleece (AGM) or gel
battery. Refer to the specifications in the "Technical data" section.
Do not use the charger to charge batteries with other operating voltages!
• Connect the appropriate adapter cable to the charging cable. The plugs can only be connected in the correct polar-
ity. Check that the cables are connected properly. The locking mechanism should click into place.
• To unplug the adapter cable from the charging cable, press gently on the latch and pull the cables apart. Do not
force the cables apart if the locking mechanism has not been released.
• Insert the mains plug into a mains socket (100-240 V/AC, 50/60 Hz). The charger will switch on and check each
charging function. The LED indicators will turn on briefly.
The charger has an automatic memory function, i.e. it automatically selects the previous charging mode
when it is connected to the mains.
9
Publicité
