Publicité
All manuals and user guides at all-guides.com
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfe-
rence to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
lf this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encou-
raged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Should you need further certification information (FCC ID, IC) please open the cover at
the bottom of the product by rotating it counterclockwise with the palm of your hand.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This transmitter should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your
body and must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2016-06-QSG-WS-V23.indd 10
Caution!
Any changes or modifications to this unit not expressly approved by the party res-
ponsible for compliance could void the user's authority to operate the equipment.
Legal notice
"Made for iPod", "Made for iPhone", "Made for iPad" mean that an electronic ac-
cessory has been designed to connect specifically to iPod, iPhone and iPad and
has been certified by the developer to meet Apple performance standards. Apple
is not responsible for the operation of this device or its compliance with safety and
regulatory standards.
Please note that the use of this accessory with iPhone may affect wireless perfor-
mance.
Safety warnings
This device is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Use only with supplied USB wall adaptor. The USB wall adaptor is for indoor use only.
Before inserting the batteries, check that the contacts in the device and on the bat-
teries are clean, and clean them if necessary. Note the polarity (+/-) wheninserting
the batteries.
Do not throw the batteries into a fire, short-circuit it or dismantle it. Keep children
away from batteries. Seek medical attention immediately if a battery is swallowed.
22/09/2016 15:45:55
Publicité
