Menumaster DEC1800VP Serie Mode D'emploi page 11

Programming
Preprogrammed Number Pads
1. Open oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press MENU b/d pad to select preprogrammed
menu if necessary.
4. Press desired number pad.
• Display shows heating time, "COOK LEVEL" and
power level if other than 100 percent power.
5. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
6. Press POWER LEVEL pad to change power level.
• Display indicates 100 percent power.
7. Press number pad to enter desired power level.
• For example, pressing 2 pad is 20 percent power.
8. Press START pad to save new heating time and
power level in oven memory.
• Display shows "Pb" or "Pd" indicating "b" or "d"
menu.
• Repeat step 3-8 to program additional pads.
9. Press RESET pad or close oven door to exit
programming mode.
All manuals and user guides at all-guides.com
11
Multiple Heating Stages
Oven can be programmed to perform 4 independent
heating cycles without interruption.
1. Open oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad 1 for approximately 5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press MENU b/d pad to select preprogrammed
menu if necessary.
4. Press desired number pad.
• Display shows heating time, "COOK LEVEL" and
power level if other than 100 percent power.
5. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
6. Press POWER LEVEL pad to change power level.
• Display indicates 100 percent power.
7. Press number pad to enter desired power level.
• For example, pressing 2 pad is 20 percent power.
8. Press TIME ENTRY pad.
• Display briefly shows "bP1
indicating menu, programming, stage, and pad.
Then cook time and power level for stage show in
display.
• Repeat steps 5-8 to create additional stages.
9. Press START pad to save new heating time and
power level in oven memory.
10. Press RESET pad or close oven door to exit
programming mode.
(1-9,0) (1-9,0)
" or "dP1 "