Nemaxx FL 2 Mode D'emploi Original page 3

Test
1. Contrarotate the installation panel in order to remove it;
2. Remove the insulated material and make sure the battery is connected in correct way;
3. Adjust the clips of the installation panel to the notches of the detector and turn
the smoke detector clockwise in order to fasten it;
4. Depress the test button, the RED LED flashes quickly and in the mean while the
detector sounds, it means the the detector works well.
Battery replacement
1. Turn the alarm body counterclockwise and take off the cover.
2. Take out the battery. Place the new battery to the power connector.
3. Put the top cover back on and turn clockwise to close cover tight.
4. Always test the smoke alarm by using the test button after you replace or have taken out
the battery.
Notch
Battery
space
CAUTION!!!
Danger of explosion if a lithium battery is used and incorrectly replaced.
Please use or replace lithium batteries only with the same type of battery.
Notes
Battery types approved with this domestic smoke alarm:
C-Zn: GP 1604S, PAIRDEER 6F22
Alkaline: GP 1604A, GP 1604AU, OSEL 6LR61, PAIRDEER 6LR61
Lithium: FORTE ER9V, GP CR-V9, EVE CR-9V/P, ULTRALIFE ULVL-J, FANSO ER9V
All manuals and user guides at all-guides.com
EN
Back side of
bottom cover
3
Version: 7.0
16.02.2017
9V
battery