FH 7000 – FH 7001
FH 7001 – Oscillation button on the base: "I" position turn on oscillation function; "0" position turn off
oscillation function.
Thermostat knob:
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position I or position II the heater will automatically switch on as soon as the room temperature falls below
the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower temperature
setting.
You may adjust the thermostat during use.
Control lamp:
The control lamp indicates the operation if any st
If the steps switch turned on position 0 or the device by the electricity mains is taken, the control lamp
goes out.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot.
MAINTENANCE
Cleaning.
We recommend that you clean your heater at least twice a year to remove accumulated dust and dirt.
- Set the selector switch to position 0 to switch off. Remove the mains plug from the wall socket. Wait for
the heater to cool down sufficiently.
- You may clean the outside of the heater with a damp cloth or brush. Do not use water or allow water to
come into the appliance. Do not use any abrasive and caustic cleaning agents!
- Never touch the heater in water! Danger to life!
- Clean the air inlet and outlet grilles regularly with a vacuum cleaner, using the brush attachment.
Storage
Keep the original box in which the heater was packed to store it during the warmer months when it is not in
use. Clean the heater according to the instructions under
Pack the heater in the original box and store it in a cool, dry place.
TECHNICAL CHARACTERISTICS
Model: FH 7000 – FH 7001
Voltage: 220 V – 240 V
Power: Maximum 2000 W
Tension: 50 Hz.
ep is turned on in combination with the thermostat switch.
13