Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
EN
Presence Detecting
Many users forget to turn off the device at the end of the day, or waste energy
since they don't stay at the same place during the day. Presence detecting system
is operated automatically with the pressure put on the upper surface of the
device. When the device is operated at 1st and 2nd levels, if it does not sense any
presence for 30 minutes (if the person does not apply any pressure on the device),
it will switch to stand-by position and stop the warming. This feature decreases
the energy consumption significantly in case of a typical use.
Running the Device Continuously (at Turbo Timer Mode)
When you want to warm your feet up faster, you can switch to Turbo Timer mode
and operate the device uninterruptedly for 4 hours at maximum power. At the
end of this time, the device will go back to the latest power level that it was
adjusted to, and presence detecting will be enabled.
In order to use the device at Turbo Timer, when the Foot Warmer is operating
at either 1st or 2nd level, it will be enough to press Turbo Timer button on the
remote control. In order to get out of Turbo Timer, you need to press Turbo Timer
button again. When you get out of Turbo Timer, the foot warmer will go back to
the level it was previously operating on before being put on Turbo Timer. When
the device is running on Turbo Timer, Turbo Timer light on the Dashboard lights
up.
Turning Off the Device
Turbo Foot Warmer can be turned off in 3 ways:
1- The warmer turns off automatically within 30 minutes when no pressure is
applied on the device.
2- It turns off when POWER button on the remote control is pressed.
3- It turns off when On/Off button on the device is pressed for a long time.
Attention: Unless the device is not plugged out, the stand-by light on the device
will be on.
23
Publicité
