Lorell Sit-to-Stand 99548 Instructions D'assemblage page 3

Assembly Instructions
STEP 6
C
STEP 7
Connect to electricity and press
button to adjust to a higher position.
Use 4 pcs M5*8 screws to assemble
the top panel.
G
L
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to be sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packing straps before you start to assemble.
• Don't tighten all screws/bolts until all completely assembled.
• Keep all hardware parts out of reach of children.
• It is recommended for 2 persons to complete this assembly.
A
B
D
C
X 4
X 1
Electric Sit Stand Workstation with Keyboard
Place table panel (part C) through center leg.
Assemble 8 pcs "F" screws but do not tighten.
Keep desk top panel in horizontal position and
then tighten all 8 pcs "F" screws.
F
M
A
Assemble decorating rubber "H".
H
B
99548/99549
X 8
X 1
Two people are required to
assemble and move this model.