Lorell Sit-to-Stand 99548 Instructions D'assemblage page 2

Assembly Instructions
STEP 3
B
L
Assemble the bottom cover (refer to step 1).
STEP 5
Adjust wire in the cable clamp behind the center leg.
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to be sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packing straps before you start to assemble.
• Don't tighten all screws/bolts until all completely assembled.
• Keep all hardware parts out of reach of children.
• It is recommended for 2 persons to complete this assembly.
Electric Sit Stand Workstation with Keyboard
STEP 4
A
Use 2 pcs M6*10 screws and washers to
assemble at the rear position.
Tighten 4 pcs side screws (refer to step 2).
Note: It's recommended to install rear screws
F X 2
M X 1
N X 2
with unit upside down.
99548/99549
Two people are required to
assemble and move this model.